Directed Electronics 381 Series Installationsanleitung PDF herunterladen (Seite 28)

TROUBLESHOOTING

Starter kill does not work:

Is the correct starter wire being interrupted? If the car starts when the starter kill relay is completely dis-

connected, the wrong starter wire has been cut and interrupted.

Are the green and black wires properly oriented? The green goes toward the switch, and the black towards

the starter motor.

Starter kill does not work only in the VRS

mode:

Yellow wire is not connected to true ignition. It is connected to an accessory circuit.

Shock sensor does not trigger the alarm:

Has the NPC

™

system been triggered? If so, you will hear 5 chirps when disarming. To check this, turn the

ignition key on and off to clear the NPC

™

from memory, and then retest the shock sensor. For a detailed

description of NPC

™

, see Owner’s Guide.

Door input does not immediately trigger full alarm. Instead, first I hear chirps for 3 seconds:

That’s how the progressive two-stage door input works! This is a feature of this system. This is an instant

trigger, remember, since even if the door is instantly closed, the progression from chirps to constant siren

will continue.

Closing the door triggers the system, but opening the door does not:

Have you correctly identified the type of door switch system? This happens often when the wrong door

input has been used.

System will not passively arm until it is remotely armed and then disarmed:

Are the door inputs connected? Is a blue wire connected to the door trigger wire in the vehicle? Either the

green H1/5 or the violet H1/7 should be used instead.

Door input does not respond with the progressive trigger, but with immediate full alarm:

What zone does the LED indicate? If the LED indicates that the impact sensor caused the trigger, the sen-

sor may be detecting the door opening. Reducing the sensitivity or relocating the sensor can often solve

this problem. If the LED indicates that the door caused the trigger, you may have programmed the pro-

gressive door trigger off. See Feature 2-4 of the

Feature Descriptions

section.

The Valet

/Program switch does not work:

Is it plugged into the correct socket?

Status LED does not work:

Make sure that it is plugged in. See

Plug-In Harnesses

section. Is the LED plugged into the correct socket?

1 2 ... 23 24 25 26 27 28

Kommentare zu diesen Handbüchern

Keine Kommentare

Directed Electronics 381 Series Installationsanleitung Seite 28

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Auto Alarmanlage Directed Electronics 381 Series