Directed-electronics 991 Bedienungsanleitung PDF herunterladen (Seite 32)

remote will respond with error tone.

Rear defogger

Command

: Press

A U X

four times, and then

A U X

. (Only after remote

start is on.)

Feedback

: Defogger icon appears on remote and text reads Defrost

On.

Notes

: While the remote start is running the defroster will manu-

ally be turned on for one remote start cycle. When the

remote start shuts down, the defroster will work normally.

The defroster turns on when the temperature inside the

vehicle is 55 degrees or below when this feature is

wired and enabled.

Smart start

Command

: Press

A U X

three-times and then press

A U X

Feedback

: The vehicles parking light ash 5 times fast and the text

on the 2way remote reads Smart Start On

Notes

: Enables or disables the SmartStart feature. The smart

start feature of this system will allow you to have the

remote start activate when the vehicle reaches a certain

temperature (hot or cold) or a certain voltage. The fac-

tory setting for temperature high is 100 °F the setting for

low is 0 °F. The voltage setting is for 10.5V.

These settings can be adjusted or turned off by your

installer when using the Bitwriter.

To activate the Smart Start Mode with a manual transmission:

Enter the MTS procedure.1.

Exit the vehicle and press the 2.

A U X

button on the remote (the vehicle

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 59 60

Keine Kommentare

Directed-electronics 991 Bedienungsanleitung Seite 32