Directed Electronics Valet 561T Installationsanleitung PDF herunterladen (Seite 17)

1177

Connect this wire to the second ignition or accessory wire in the vehicle. (Selectable by using Feature 9.)

NNOOTTEE::

For vehicles that do not have a second ignition or accessory wire, this connection is not

required.

rreemmoottee ssttaarrtt hhaarrnneessss ((HH22)),, 55--ppiinn ccoonnnneeccttoorr

Connect this wire to the toggle (override) switch as shown in Figure A. Connect the other wire from the toggle switch

to the PARK/NEUTRAL switch in the vehicle. This wire will test with ground with the gear selector either in PARK or

NEUTRAL. This will prevent the vehicle from accidentally being started while in a drive gear. This input MUST rest at ground

in order for the remote start system to operate. Connected properly the vehicle will only start while in PARK or NEUTRAL.

In some vehicles, the PARK/NEUTRAL position switch activates a factory starter lock-out that will not allow the

starter to operate in a drive gear. In these vehicles, connect this wire to the toggle switch as shown in Figure B.

Connect the other wire from the toggle switch to chassis ground.

FFiigguurree AA FFiigguurree BB

IIMMPPOORRTTAANNTT!!

Always use the Vehicle Safety Check section of this guide to verify that the vehicle

cannot be started in ANY drive gear and that the override switch is functioning properly.

This input provides the module with information about the engine's revolutions per minute (RPMs). It can be con-

nected to the negative side of the coil in vehicles with conventional coils. In multi-coil and high energy ignition

systems locating a proper signal may be more difficult. (See

Finding the Wires You Need

section of this guide for

finding the tachometer wire.) Once connected, you must teach the system the tach signal. (See

Tach Learning

section of this guide.)

HH22//22 VVIIOOLLEETT//WWHHIITTEE ttaacchhoommeetteerr iinnppuutt

HH22//11 BBLLAACCKK//WWHHIITTEE nneeuuttrraall ssaaffeettyy sswwiittcchh iinnppuutt

PPIINNKK//WWHHIITTEE ((++)) oouuttppuutt ttoo sseeccoonndd iiggnniittiioonn//aacccceessssoorryy cciirrccuuiitt

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 38 39

Keine Kommentare

Directed Electronics Valet 561T Installationsanleitung Seite 17