Directed Electronics RSIII Installationsanleitung PDF herunterladen (Seite 16)

2002

Directed Electronics, Inc.

Remote Start Harness Wire Descriptions

H3/1 BLUE Status Output

This wire supplies a 200mA output as soon as the module begins the remote start process and is

normally used to activate an immobilizer bypass module. The H3/1 BLUE wire can also be

programmed to rearm a factory anti-theft system when the remote start shuts down. (See the Feature

Descriptions section in this guide.)

NOTE: This wire can also be used to bypass optional sensors and door triggers as described in the

following diagram.

To bypass an optional sensor:

H3/2 BLUE/BLACK (-) Optional Third Ignition Output

This output provides 200mA as soon as the remote starter is activated. It can be used to power a

relay to energize a positive (+) third ignition as shown below. This output is capable of driving two

relays if necessary.

SENSOR TRIGGER OUTPUT

SENSOR INPUT OF SYSTEM

(+) 12V FUSED

CUT

87A

DIA-141

H3/1 BLUE STATUS

OUTPUT

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 43 44

Keine Kommentare

Directed Electronics RSIII Installationsanleitung Seite 16