Directed Electronics VS102 Spezifikationen PDF herunterladen (Seite 25)

Peripheral Interfacing Options with Vocollect Voice Appliances Page 17

1-Dec-2010 Version 4.0

Understanding Bluetooth Pairing

With Scanners

Basic Bluetooth Roles and Concepts

Pairing: Two Bluetooth devices are paired with each other by configuring each device’s mode.

These modes are:

Acceptor – the device configured as an acceptor will accept a connection from the

other device. It will not attempt to actively connect to any other device. It may

require some security information from the initiator device before accepting the

connection.

Initiator – the device will actively search for (page) and connect to the other device

(which must be discoverable and configured as an acceptor). If security settings have

been configured on the initiator device, it may need to present these settings to the

acceptor to complete the connection.

MAC address: Bluetooth devices such as scanners are identified by a unique 12 hexadecimal

(base 16) address (i.e. composed of the numbers 0-9 and letters A-F, typically expressed in

pairs separated by “-“ or “:” such as 08-00-2B-1F-3D-47 or 00:00:2F:E0:BC:7C). This address

is sometimes called the “Bluetooth MAC address” (Media Access Control).

Talkman T5 Series terminals have this address as a barcode on the rear of the terminal on

the label printed with “BT” for “Bluetooth”. Similarly most scanners will also have their

Bluetooth address printed and/or expressed in bar code on the device.

Configuring Talkman T5 Series Bluetooth

Capabilities With VoiceConsole

Talkman T5 Series is configured with the management software, VoiceConsole, to enable

Bluetooth on the Talkman terminal. Pairing of the Talkman with a Bluetooth device can be

done in either of two ways: (1) the connection is initiated by the Talkman; or (2) the

connection is initiated by the Bluetooth device.

Connection initiated by the Talkman

This is useful when it is desired that a specific Talkman and device are consistently used

together to make troubleshooting easier. It is important that Talkman terminals and their

associated devices must be labeled so that the correct pairs are consistently used.

However, it also may restrict use to ways that are not convenient. One disadvantage of this

set-up is that if there is a problem with a particular scanner, then it must be swapped out

using VoiceConsole.

To enable Talkman to initiate a connection with a device, using VoiceConsole:

1. Set the parameter “Bluetooth_IsEnabled” to “TRUE” in the advanced settings of the

device profile.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 55 56

Keine Kommentare

Directed Electronics VS102 Spezifikationen Seite 25