Directed Electronics VS102 Spezifikationen PDF herunterladen (Seite 53)

Peripheral Interfacing Options with Vocollect Voice Appliances Page 45

1-Dec-2010 Version 4.0

Peripheral operation – Intermec SF-51 Flashlight Scanner & Talkman T5 Series Page 45

Rev 1.0/jjd

Scanner initiating pairing to the Talkman

This method of pairing is useful it a scanner is to be picked up needs to be paired with a Talkman.

Use The EasySet Tool from Intermecto generate barcode:

1. Install EasySet version 5.4 or later on a host PC. EasySet is Available on the CD that

shipped with the SF51 or from the Intermec web site at www.intermec.com.

2. Start EasySet. Make sure that SF51 is selected as your Product.

3. From the EasySet commands window, select Data Transmission settings > Bluetooth

parameters > connect/Disconnect.

4. Double-click compose BT address.

5. Enter the Bluetooth address of the Talkman to be paired and Click OK. The bar code

appears on the setup sheet.

6. Scan the bar code onscreen with the SF51, or print the bar Code setup sheet and scan

the bar code.It may be convenient to place this label on the rear of the Talkman on

the opposite side of the Bluetooth label where it will be protected from wear.

Using VoiceConsole, locate the specific terminal to be paired with the scanner.

View the detailed properties of the Talkman T5 series terminal and assure that Bluetooth is

enabled; if it is not, click on “Edit this device” and set “Bluetooth Enabled” to “enabled”

11. Select the “Pair this device with a peripheral” option

12. For “Pairing Type” select “Bluetooth Scanner”

13. For “Connection Mode” select “Device listens for peripheral connection”

14. Select “Enabled” for “Security”

15. Enter four zeros “0000” as the “Security Key”

16. Click “Pair with peripheral” to initiate pairing

17. Scan the barcode that was created and placed on the terminal in the initial step

The scanner should now pair with the Talkman. Note that this may take several minutes.

Note that many of the above settings may be done via creating a specific device profile in

VoiceConsole. This is the recommended approach for production use.

Important – When finished using the Talkman and scanner for the day it is advisable to unpair the

Talkman from the scanner by setting the scanner to slave mode. This may be done by scanning the

following barcode.

Bluetooth - connect/disconnect - disconnect (*)

\60\02\52\05\00\00\06\00\00\00\00\00\00\00\00\00

1 2 ... 48 49 50 51 52 53 54 55 56

Keine Kommentare

Directed Electronics VS102 Spezifikationen Seite 53