Directed Electronics 200 Installationsanleitung PDF herunterladen (Seite 13)

When the system receives the code controlling Channel 2 for longer than 1.5 seconds, the red/white wire will

supply an output as long as the transmission continues. This can be used to operate an optional relay-driven

function.

IMPORTANT! Never use this wire to drive anything but a relay or a low-current input! The transis-

torized output can only supply 200 mA of current. Connecting directly to a solenoid, motor, or other

high-current device will cause it to fail.

This output can be programmed to provide the following types of outputs (see System Features Learn Routine

section of this guide):

■ When the transmitter button(s) controlling Channel 2 is pressed for longer that 1.5 seconds, a delayed valid-

ity output will send a signal as long as the transmission is received.

■ A latched output will send a signal continuously when the Channel 2 transmitter button(s) is pressed and

will continue until the button(s) is pressed again.

■ A latched/reset with ignition output works similar to the latched output, but will also reset (output will

stop) when the ignition is turned on then off.

■ A 30-, 60- or 90-second timed output will send a signal for 30, 60, or 90 seconds, respectively, when the

Channel 2 transmitter button(s) is pressed.

Refer to H1/10 BLACK/WHITE starter kill wire description.

Refer to H1/6 WHITE (+) light flash output wire description.

H1/14 WHITE (+) light flash output

H1/13 BLACK/WHITE starter kill wire

H1/12 RED/WHITE channel 2, 200mA (-) output

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 23 24

Keine Kommentare

Directed Electronics 200 Installationsanleitung Seite 13