Directed Electronics 200 Installationsanleitung PDF herunterladen (Seite 16)

transmitter/receiver learn routine

The system comes with two transmitters that must be “taught” to the receiver. Use the following learn routine

to program the transmitters, add transmitters to the system or to change button assignments if desired.

IMPORTANT! All remotes that will be used with the system must be programmed at the same time.

Each time the learn routine is accessed and a remote is successfully learned by the system, any

other remotes that had previously been programmed will be erased.

1. Make sure that the system is disarmed.

2. Turn the ignition ON-OFF-ON-OFF-ON. The siren will chirp to indicate that the transmitter is ready to be pro-

grammed.

3. Press the transmitter button(s) that corresponds to one of the Auto-Learn Configurations (1, 2 or 3) in the

table below. Auto-Learn Configuration 1 (separate arm and disarm buttons) is the default setting that the

transmitters come programmed with from the factory.

4. The siren will chirp to confirm that the desired Auto-Learn Configuration has been programmed.

5. Repeat Steps 1-4 until all transmitters have have been taught to the receiver.

The learn routine will be exited when the ignition is turned off or if 10 seconds elapse between programming

steps. The siren will emit a short chirp and then a long chirp to indicate that the learn routine has been exited.

FOR PRESS

AUTO-LEARN TRANSMITTER BUTTON I BUTTON II BUTTONS I AND II

CONFIGURATION BUTTON(S) FUNCTION FUNCTION FUNCTION

1 I and II Arm only, Panic Disarm, Channel 2 Channel 3

2 I Arm, Disarm, Panic Channel 2 Channel 3

3 II Channel 2 Arm, Disarm, Panic Channel 3

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 22 23 24

Keine Kommentare

Directed Electronics 200 Installationsanleitung Seite 16