Directed Electronics Automate 210D Betriebsanleitung PDF herunterladen (Seite 12)

Installation Instructions

Ambient Conditions

Before you set up your balance, choose a suitable

place which meets the following requirements:

– level, low-vibration weighing table

or a wall console;

– no direct exposure to sunlight, heaters, or similar

sources of heat. This can considerably

increase the temperature inside the draft shield

(greenhouse effect), resulting in incorrect readouts

due to convection currents, turbulence and

buoyancy effects;

– no drafts from open windows or doors;

– avoid brief fluctuations in room temperature.

The balance is not allowed to be used in hazardous

areas/locations where there is danger of explosion.

Do not expose the balance to extreme moisture

over long periods. Moisture in the air can condense

on the surfaces of a cold balance whenever it

is brought to a substantially warmer place.

If you transfer the balance to a warmer area, make

sure to condition it for about 2 hours at room

temperature, leaving it unplugged.

1–8

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 187 188

Keine Kommentare

Directed Electronics Automate 210D Betriebsanleitung Seite 12