Directed Electronics Matrix 1 Installationsanleitung PDF herunterladen (Seite 15)

www.clifford.com

H1/6 Blue wire, all trigger inputs except the door trigger input will remain bypassed until 5 seconds

after ground is removed from the BLUE wire. This can be done using the status output of a Directed

Electronics remote engine starting unit as shown in the following diagram:

System Features Learn Routine

The System Features Learn Routine dictates how the unit operates. Due to the number of steps,

they have been broken up into two menus. It is possible to access and change any of the feature

settings using the Valet/Program switch. However, this process can be greatly simplified by using the

998T Bitwriter. Any of the settings can be changed and then assigned to a particular transmitter, up

to four, a feature called Owner Recognition. Each time that particular transmitter is used to disarm

the system, the assigned feature settings will be recalled. Owner Recognition is only possible when

programming the unit via the 998T Bitwriter.

If the system was previously programmed using the 998T Bitwriter, the learn routine may be

locked. If the siren generates one long chirp when attempting to program the unit, the learn routine

is locked and must be unlocked using the 998T Bitwriter.

DIA-593

1N4004 DIODE

TO OPTIONAL HOOD/

TRUNK PINS OR SENSORS

CONTROL UNIT

551T REMOTE

START UNIT

BLUE (-) STATUS

OUTPUT

BLUE WIRE H1/6

ZONE 1 INPUT

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 29 30

Keine Kommentare

Directed Electronics Matrix 1 Installationsanleitung Seite 15