Directed Electronics Matrix 1 Installationsanleitung PDF herunterladen (Seite 28)

2005

Optional Vehicle Recovery System (VRS)

VRS is an optional feature designed to disable a vehicle during a carjacking event. It must be

programmed in the features menu and the Failsafe Starter Kill must be installed for it to work

properly. For operational instructions when testing VRS refer to the owner's manual.

False Alarm Control Technology (FACT)

FACT requires that you change the way you test the system, as FACT will bypass an input zone for

60 minutes. If the system detects the same zone triggering three times AND the triggers are spaced less

than an hour apart, the system will bypass that input zone for 60 minutes. If that zone does not attempt

to trigger the system during the 60-minute bypass period, the zone’s monitoring will begin again at

the end of the hour. If it does attempt to trigger while bypassed, the 60-minute bypass starts over again.

Disarming and rearming the system does not reset FACT. The only way to reset FACT is for the 60

minutes to pass, without a trigger, or for the ignition to be turned on. This allows the system to be

repeatedly triggered, disarmed and rearmed, while still allowing FACT to bypass a faulty zone.

When disarming the system, 5 chirps indicate FACT is activated. The LED will report the zone that

has been bypassed. (See

Table of Zones

section of this guide.)

Smart Power Up II

The Smart Power Up II feature ensures that when the security system is powered back up after power has

been disconnected, the system will resume the same state it was in before power was lost. For example, if

power is disconnected during a full trigger sequence, the system will still be in the full trigger sequence when

power is reconnected to the unit. If power is disconnected while the unit is disarmed, it will still be disarmed

when power is restored. This also applies to the VRS sequence. If the unit loses power at any time during the

VRS sequence, it will automatically resume the VRS full trigger sequence when the unit is powered back up.

1 2 ... 23 24 25 26 27 28 29 30

Keine Kommentare

Directed Electronics Matrix 1 Installationsanleitung Seite 28